欢迎进入深圳市东方慧通化工科技有限公司官网!
热线电话:0755-85207605  手机:18319052829招商加盟|联系我们

产品中心

Product Center
高覆盖白色墙面基膜
文名: High coverage white wall base film

规格:4KG、1KG、16KG

多功能配方

Multifunctional formula

高遮盖力

High covering power

防潮性能强

Waterproof Performance Is Strong

滑爽易施工

Smooth and easy to construct


产品说明

  

产品介绍:

本品是一种多功能墙面处理剂,水性环保,用于墙面防潮、抗碱和防霉的处理。能在墙面形成一层密实的白色保护膜,为粘贴墙纸或墙布提供良好的基面,有效保护墙纸或墙布不受侵蚀。同时也增强墙纸或墙布与基面的附着力,而更加牢固,便于墙纸、墙布施工时粘贴的调整等优点。
适用范围:使用于多孔吸收性的批灰墙面、石膏面板等。
墙面处理:预涂墙面表面必须结实,干净,没有油污。PH值<10并干燥无发霉现象,使用前请彻底清除有任何粉化或松脱的外层。
施工方法:可滚涂、刷涂、喷涂于预涂墙面,不兑水直接使用,也可根据需要加入清水10%-50%,使用前充分搅拌均匀,涂刷2遍或以上。
施工条件:施工时墙面温度+6℃至35℃,相对湿度﹤85%,并在通风环境中进行施工。
技术参数:

颜色

白色

状态

液态

PH值

约8

表干

1-2小时

理论用量

不兑水涂刷1遍约6-8㎡/kg

注:以上数据仅供参考,表干时间,因各地施工环境不同,而有所差异。实际涂刷面积视墙面细孔的吸收性而定,基膜干燥后呈白色。

储存条件:请密闭存放于+6℃至35℃的干燥通风环境,避免阳光照射。

期:24个月

生产日期:见包装标注

执行标准:GB 18582-2008

注意事项:

① 如施工时发现异常现象,请立即停止施工,并咨询销售商以取得技术支持。

不能有部分墙面漏涂,以避免漏涂部分粘贴墙纸或墙布后产生起泡。

避免与皮肤接触,如不慎入眼,立刻用大量清水清洗,如需要请即就医。

请妥善保管,切勿放置在儿童能够接触到的地方。

 

Product introduction:

This product is a multi-functional wall treatment agent, water-based environmental protection, used for wall moisture-proof, alkali resistant and mildew resistant treatment. It can form a dense white protective film on the wall, provide a good base for pasting wallpaper or wall cloth, and effectively protect the wallpaper or wall cloth from erosion. At the same time, it also enhances the adhesion between wallpaper or wall cloth and the base surface, and is more firm, which is convenient for the adjustment of the paste during the construction of wallpaper and wall cloth.

Scope of application: It is used for porous and absorbent plaster wall, gypsum board, etc.

Wall treatment: The surface of the pre coated wall must be firm, clean and free of oil stain. PH value < 10 and dry without mildew, please thoroughly remove any powdered or loose outer layer before use.

Construction method: It can be rolled, brushed or sprayed on the pre coated wall, directly used without mixing water, or added with 10% - 50% clean water as required. Before use, it can be fully stirred and brushed twice or more.

Construction conditions: During construction, the wall temperature is + 6 ℃ to 35 ℃, the relative humidity is less than 85%, and the construction is carried out in a ventilated environment.

Technical parameters:

colour

white

state

liquid state

PH value

About 8

Surface dry

1-2 hours

Theoretical dosage

Brush once without water, about 6-8 ㎡ / kg

Note: The above data is for reference only. The table drying time varies with different construction environments. The actual painting area depends on the absorption of the wall pores, and the base film is white after drying.

Storage conditions: Please store in a dry and ventilated environment with temperature between +6 ℃ and 35 ℃ to avoid sunlight.

quality guarantee period: 24 months

date of manufacture: See package label

Executive standard: GB 18582-2008

matters needing attention:

1.   If any abnormal phenomenon is found during the construction, please stop the construction immediately and consult the seller for technical support.

2.   No part of the wall shall be missed to avoid blistering after the missing part is pasted with wallpaper or wall cloth.

3.   Avoid contact with the skin. If it enters the eye, wash it immediately with plenty of water. If necessary, please see a doctor.

4.   Please take good care of it and do not put it in a place where children can touch it.